Operation CHARM: Car repair manuals for everyone.

Rear Door Window Regulator: Service and Repair





Rear Door Window Regulator and Motor

Special Service Tools






Door glass release lever

501-114

Removal

NOTE:
The door glass should be lowered by approximately one third.
1 Remove the rear door trim panel. For additional information, refer to Rear Door Trim Panel




2 Remove the speaker.
- Disconnect the electrical connector.
- Remove the 4 screws.




3 Carefully remove the outer waist seal.
- Remove the screw.




4
NOTE:
Wedge the glass in this position.
Using the special tool, release the clip and lift the glass to the top of the door frame.




5 Remove the window motor and regulator assembly.
- Disconnect the electrical connector.
- Remove the 4 bolts.
- Remove the 2 nuts.
- Rotate the assembly 90 degrees clockwise, to remove the upper part of the assembly from the rear side of the aperture first.

Installation
1 Install the window motor and regulator assembly.
- Tighten the bolts and nuts to 10 Nm (7 lb.ft).
- Connect the electrical connector.
2 Secure the glass to the glass regulator.
- Remove the wedge.
- Lower the glass.
3 Install the outer waist seal.
4 Install the speaker
- Tighten the screws.
- Connect the electrical connector.
5 Install the rear door trim panel. For additional information, refer to Rear Door Trim Panel