C-Pillar Lower Trim Panel

C-Pillar Lower Trim Panel

Removal
1 Fold down the rear seat backrest.




2 Release the door aperture weatherstrip.




3 Release the safety belt anchor.
- Remove and discard the bolt.




4 Release the tailgate aperture seal.




5 Remove the support spigot from the tailgate.
- Release the clip.




6 Remove the C-pillar lower trim panel.
- Remove the Torx screw.
- Release the 8 clips.
- Disconnect the 2 electrical connectors.
7
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the stowage tray.
- Release the cover.
8 Remove the audio control switch.
- Release the 2 clips.




9 Remove the accessory socket.

Installation
1 Install the accessory socket.
2 Install the audio control switch.
- Secure the clips.
3 Install the stowage tray.
- Install the cover.
4 Install the C-pillar lower trim panel.
- Install the clips.
- Tighten the Torx screw to 8 Nm (6 lb.ft).
- Connect the electrical connector.
5 Install the support spigot to the tailgate.
- Install the clip.
6 Install the tailgate aperture seal.
7 Install the safety belt anchor.
- Tighten the Torx bolt to 45 Nm (33 lb.ft).
8 Install the door aperture weatherstrip.
9 Return the seat backrest to the upright position.