Floor Console Upper Panel

Floor Console Upper Panel

Removal
1 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System




2 Remove the floor console stowage compartment.
- Open the floor console stowage compartment lid.
- Remove the 2 screws.
- Carefully release the 2 clips.
- Disconnect the cigar lighter electrical connector.




3
CAUTION: Make sure damage does not occur to the vehicle trim when removing the centre console side finisher trim panel.
NOTE:
Left-hand shown, right-hand similar.
Remove the center console LH side finisher trim panel.
- Using a suitable tool, carefully release the 3 clips.
4
CAUTION: Make sure damage does not occur to the vehicle trim when removing the centre console side finisher trim panel.
Remove the center console RH side finisher trim panel.
- Using a suitable tool, carefully release the 3 clips.
5 Remove the selector lever knob. For additional information, refer to Selector Lever Knob




6 Remove the climate controlled seat switch trim panel.
- Carefully release the 4 clips.
- Remove the 2 front screws from the floor console upper panel.




7 Reposition the floor console upper panel.
- Using a suitable tool, carefully release the 4 clips.
- Remove the 4 screws.




8 Disconnect the parking brake switch electrical connector.




9 Remove the floor console upper panel.
- Release the 3 wiring harness clips.
- Disconnect the 3 electrical connectors.





10
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the floor console cup holder.
- Remove the 6 screws.





11 Remove the parking brake switch.
- Remove the parking brake switch trim panel.
- Remove the 2 screws.





12 Remove the upper floor console stowage compartment.
- Remove the 4 screws.





13 Remove the ride and handling optimization switch assembly.
- Remove the 6 screws.

Installation
1 Install the ride and handling optimization switch assembly.
- Install the 6 screws.
2 Install the upper floor console stowage compartment.
- Install the 4 screws.
3 Install the parking brake switch.
- Install the 2 screws.
- Install the parking brake switch trim panel.
4 Install the floor console cup holder.
- Install the 6 screws.
5 Install the floor console upper panel.
- Connect the 3 electrical connectors.
- Attach the 3 wiring harness clips.
6 Connect the parking brake switch electrical connector.
7 Reposition the floor console upper panel.
- Secure the 4 clips.
- Install the 4 screws.
8 Install the climate controlled seat switch trim panel.
- Install the 2 front screws to the floor console upper panel.
- Secure the 4 clips.
9 Install the selector lever knob. For additional information, refer to Selector Lever Knob

10 Install the center console LH side finisher trim panel.
- Secure the 3 clips.

11 Install the center console RH side finisher trim panel.
- Secure the 3 clips.

12 Install the floor console stowage compartment.
- Connect the cigar lighter electrical connector.
- Secure the 2 clips.
- Install the 2 screws.
- Close the floor console stowage compartment lid.

13 Connect the battery ground cable. For additional information, refer to Specifications Battery and Charging System