A-Pillar Trim Panel
A-Pillar Trim Panel
Removal
WARNING: The air bag is mounted directly under this component, extreme care is necessary.
1 Release the door aperture weatherstrip for access.
2 Release the screw cover.
- Remove the Torx screw.
3 Remove the A-pillar upper trim panel.
- Carefully release the 2 clips.
4
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the 2 clips.
Installation
1 Install the clips.
2
CAUTION: Make sure the Torx screw is not over tightened. Failure to follow this instruction will result in damage to the vehicle.
Install the A-pillar upper trim panel.
- Secure the clips.
- Tighten the Torx screw to 2 Nm (1.5 lb.ft).
- Install the screw cover.
- Install the door aperture weatherstrip.