Fender Splash Shield

Fender Splash Shield

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the front wheel.




3
NOTE:
RH side only.
Remove the fender splash shield lower extension panel.




4
NOTE:
RH side only.
Remove the fender splash shield upper extension panel.




5
CAUTION: LH illustration shown, RH is similar.
Remove the front fender splash shield.
- Remove the 3 nuts.
- Remove the 13 screws.
- Disconnect the tire pressure monitoring system front antenna electrical connector.
6
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the tire pressure monitoring system front antenna.
- Release the 2 clips.

Installation
1 Install the tire pressure monitoring system front antenna.
2 Install the front fender splash shield.
- Connect the tire pressure monitoring system front antenna electrical connector.
- Tighten the screws.
- Tighten the nuts.
3
NOTE:
RH side only.
Install the fender splash shield upper extension panel.
- Tighten the bolts to 8 Nm (6 lb.ft).
4
NOTE:
RH side only.
Install the fender splash shield lower extension panel.
5 Install the front wheel.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).