Tire Pressure Monitoring System Front Antenna

Tire Pressure Monitoring System Front Antenna

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the front wheel.




3 Release the front of the fender splash shield.
- Remove the plastic nut.
- Remove the 6 screws.




4 Remove the tire pressure antenna.
- Disconnect the electrical connector.
- Release the 2 clips.

Installation
1 Install the tire pressure antenna.
- Install the 2 clips.
- Connect the electrical connector.
2 Secure the fender splash shield.
- Tighten the screws.
- Tighten the nut.
3 Install the front wheel.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).