Pre-Check

PRE-CHECK

1. RANGE AND FIELD OF VISION




The range that the Night View Camera takes images is shown.

HINT: The Night View Camera has an adjustment mechanism (for 3 directions; right and left, up and down, and rotation).

If the range that the Night View camera takes images is different from the range shown, adjustment is required.




2. OPERATING CONDITIONS

HINT:
- Each time the ignition switch is turned ON, the Night View Switch also needs to be turned ON to activate the system.
- Approximately 1 second after the conditions are met, the image will be displayed.
- The Night View Display has a cover. This cover is closed when the display does not operate. If the open and close operation of the display cover is not normal, turn the ignition switch OFF once and then begin the operation again (In this case, the display cover opens first and then closes).

3. INSPECTION MODE




The inspection mode is used to check the Night View Projectors when the vehicle is not moving or the surroundings are bright (daytime).

This mode will automatically turn OFF after 5 minutes.

a. Inspection Mode procedure.
1. Ignition switch and headlight OFF.
2. Headlight dimmer switch ON.
3. While pressing the Night View Switch, turn the ignition switch from OFF -> ON -> OFF -> ON.
4. Release the switch. The MAIN indicator should be ON.
5. Press the switch again and the BEAM indicator light should come on.
6. The Night View Projectors should be ON.
7. Display cover should open.
8. The Display should come on approximately 1 second after the display cover opens and an image is displayed.

b. Pressing the Night View Switch while in inspection mode will turn the BEAM light OFF, turn the projectors OFF, and close the display cover.

Also, turning the headlight dimmer switch OFF will turn the BEAM light OFF and close the display cover.

c. Turn the ignition switch off in order to exit Inspection Mode operation.

4. NIGHT VIEW CAMERA LENS CLEANING

When the camera lens becomes dirty, use the following procedure.

a. Remove the Night View Camera cover.
b. Remove the Night View Camera.
c. Spray lens cleaner on a clean soft cloth and wipe the lens.

NOTE: Do not spray cleaner directly on the lens. The cleaner may permeate through the rim of the lens, and damage the camera.

d. Reinstall the Night View Camera.
e. Adjust the aim of the Night View Camera
f. Reinstall the Night View Camera cover.