Pre-Check

PRE-CHECK

1. Warning for A/C compressor lock




If compressor lock occurs during A/C operation, the A/C switch indicator on the A/C control assembly starts blinking.

When this occurs, check for compressor lock (DTC 22) using diagnosis trouble code check, and then proceed to inspect the circuit or the component.

Compressor lock sensor circuit.

2. LIST OF OPERATION METHODS




By operating each of the A/C control switches as shown in the diagram, it is possible to enter the diagnosis check mode.

3. INDICATOR CHECK







a. Turn the ignition switch to on while pressing the A/C control AUTO SW and R/F SW simultaneously.




b. Check that all the indicators light up and go off 4 times in succession at 1 second intervals.

HINT:
- After the indicator check ends, the diagnostic trouble code check begins automatically.
- Press the OFF SW when desiring to cancel the check mode.