C1336

BRAKE CONTROL: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: C1210/36: Zero Point Calibration of Yaw Rate Sensor Undone

DTC C1210/36 - Zero Point Calibration of Yaw Rate Sensor Undone

DTC C1336/98 - Zero Point Calibration of Acceleration Sensor Undone

DESCRIPTION





INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR
(a) Perform the zero point calibration of the yaw rate and deceleration sensor. Calibration.
NEXT -- Continue to next step.
2. RECONFIRM DTC
(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.
(b) Turn the ignition switch on.
(c) Check the same DTCs are recorded Reading and Clearing Diagnostic Trouble Codes.
Result:






B -- REPLACE YAW RATE AND DECELERATION SENSOR
A -- END