C2191

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: C2191/91: Vehicle Speed Signal Error (Test Mode DTC)

DTC C2191/91 - Vehicle Speed Signal Error (Test Mode DTC)

DESCRIPTION

The tire pressure warning ECU receives a speed signal from the combination meter. This DTC is stored upon entering test mode, and cleared when a vehicle speed signal of 20 km/h (12 mph) is detected for 3 seconds or more. This DTC is output only in test mode.






WIRING DIAGRAM





INSPECTION PROCEDURE
NOTICE:
- When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
- It is necessary to perform the initialization Initialization after the registration Registration of the transmitter IDs into the tire pressure warning ECU if the ECU has been replaced.

PROCEDURE

1. CHECK DTC
(a) Check for DTCs of the multiplex communication and the electronically controlled brake system.
Result:






B -- REPAIR CIRCUIT INDICATED BY OUTPUT DTCs
A -- REPAIR CIRCUITS INDICATED BY OUTPUT DTCs
C -- Continue to next step.
2. READ VALUE OF DATA LIST
(a) Make sure that the ignition switch is off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to the ON position.
(d) Turn the Techstream on.
(e) Check the values by referring to the table below. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

Tire Pressure Monitor:





(f) Check whether the vehicle speed displayed on the Techstream changes depending on the actual vehicle speed.
OK:
The vehicle speed displayed on the Techstream changes depending on the actual vehicle speed.
NG -- REPLACE COMBINATION METER
OK -- REPLACE TIRE PRESSURE WARNING ECU