Pinout Values and Diagnostic Parameters

SEAT BELT: SEAT BELT WARNING SYSTEM: TERMINALS OF ECU

1. COMBINATION METER ASSEMBLY

(a) Disconnect the F15 combination meter assembly connector.





(b) Measure the resistance according to the value(s) in the table below.

HINT
Measure the values on the wire harness side with the connector disconnected.





* *1: w/o Occupant Classification System

(b) If the result is not as specified, there may be a malfunction in the wire harness.

(c) Reconnect the F15 combination meter assembly connector.

(d) Measure the voltage according to the value(s) in the table below.





(d) If the result is not as specified, the combination meter assembly may have a malfunction.

2. ACCESSORY METER ASSEMBLY (w/o Navigation System)





(a) Measure the voltage according to the value(s) in the table below.





* If the result is not as specified, the accessory meter assembly may have a malfunction.

3. RADIO RECEIVER ASSEMBLY (w/ Navigation System)





(a) Measure the voltage according to the value(s) in the table below.





(a) If the result is not as specified, the radio receiver assembly may have a malfunction.

4. CHECK CENTER AIRBAG SENSOR ASSEMBLY









5. CHECK OCCUPANT CLASSIFICATION ECU (w/ Occupant Classification System)





(a) Measure the voltage according to the value(s) in the table below.





* If the result is not as specified, the occupant classification ECU may have a malfunction.