Smart Access System With Push-Button Start (for Entry Function)

THEFT DETERRENT / KEYLESS ENTRY: SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Entry Function): CUSTOMIZE PARAMETERS

1. CUSTOMIZING FUNCTION WITH TECHSTREAM

HINT
The items in the table below can be customized.

NOTICE:
* When the customer requests a change in a function, first make sure that the function can be customized.
* Be sure to make a note of the current setting before customizing.
* When troubleshooting a function, first make sure that the function is set to the default setting.
(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Customize Setting / Smart key/Access or Warning.

(e) Select the setting by referring to the table below.

Smart Key/Access





(e) *: Weak radio waves will still be emitted from oscillators other than the front oscillator even when the "Front" customize setting is selected.

Warning





2. ENTRY UNLOCK MODE SWITCHING

NOTICE:
Because the key (for card type) does not have a wireless transmitter function, it cannot be used to change the entry unlock mode.

(a) To change the vehicle entry unlock mode, make sure that the vehicle power is off and simultaneously push and hold the key lock switch and another key switch for 5 seconds.

Driver door unlock default setting:

When the switches are pressed and held for 5 seconds, the entry door unlock mode changes to the mode that is not currently selected.

NOTICE:
After pressing and holding the switches for 5 seconds, wait 5 seconds before performing the same procedure again.

* Driver door unlock mode:

* When the driver door touch sensor is touched, only the driver door unlocks. When another touch sensor is touched, all doors unlock.

* All door unlock mode:

* When any touch sensor is touched, all doors unlock.

(b) The certification ECU (smart key ECU assembly) receives this signal from the door control receiver assembly and changes the smart access system with push-button start to the entry unlock mode.

(c) The certification ECU (smart key ECU assembly) sounds the buzzers of the wireless door lock buzzer assembly and combination meter assembly (buzzer) to inform the user that the mode has been changed.





HINT
The procedure only changes the entry unlock mode of the smart access system with push-button start. It does not switch the unlocking of the wireless door lock control.

3. ELECTRICAL KEY CANCEL

NOTICE:
Because the key (for card type) does not have a wireless transmitter function, it cannot be used to perform the key cancel operation.

The electrical key cancel operation disables the following functions:

* Entry Unlock/Lock

* Entry Hybrid Vehicle Control System Start

* Entry Back Door Open

* Electrical Key Lock-in Prevention

* Warning

* Memory Call

(a) The operation procedures are as follows:

Precondition:

Power switch off, driver side door closed and unlocked.

(1) Push the unlock switch of the key once.

(2) Open the driver door within 5 seconds.

(3) Push the unlock switch of the key twice within 5 seconds.

(4) Close and open the driver door twice within 30 seconds.

(Driver door: Close -> Open -> Close -> Open)

(5) Push the unlock switch of the key twice within 5 seconds.

(6) Close and open the driver door within 30 seconds.

(Driver door: Close -> Open)

(7) Close the driver door within 5 seconds.

When electrical key cancel is activated, the wireless door lock buzzer sounds twice.

To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once.