Pinout Values and Diagnostic Parameters

DOOR / HATCH: FUEL LID OPENER SYSTEM: TERMINALS OF ECU

1. CHECK ECM

(a) Disconnect the D1 and A76 ECM connectors.





(b) Measure the resistance according to the value(s) in the table below.

HINT
Measure the values on the wire harness side with the connectors disconnected.





(b) If the result is not as specified, there may be a malfunction in the wire harness.

(c) Reconnect the D1 and A76 ECM connectors.

(d) Measure the voltage according to the value(s) in the table below.





(d) If the result is not as specified, the ECM may have a malfunction.

2. CHECK COMBINATION METER

(a) Disconnect the F16 combination meter connector.





(b) Measure the resistance and voltage according to the value(s) in the table below.

HINT
Measure the values on the wire harness side with the connector disconnected.





(b) If the result is not as specified, there may be a malfunction in the wire harness.