Installation

DOOR LOCK: BACK DOOR LOCK: INSTALLATION

1. INSTALL BACK DOOR LOCK ASSEMBLY

NOTICE:
* When reusing the removed back door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
* Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.
* Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water into the connection. This may result in a malfunction of the back door lock assembly.

(a) Connect the cable.





(b) Install a new door lock wiring harness seal to the back door lock assembly.

(c) Using a T30 "TORX" wrench, install the back door lock assembly with the 3 screws.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

(d) Connect the connector.

2. INSTALL BACK DOOR SERVICE HOLE COVER Reassembly

3. INSTALL BACK DOOR TRIM PANEL ASSEMBLY Reassembly

4. INSTALL BACK DOOR LOCK COVER Reassembly

5. INSTALL TOOL CASE Reassembly

6. INSTALL UPPER TOOL BOX PANEL SUB-ASSEMBLY Reassembly

7. INSTALL BACK DOOR TRIM COVER Reassembly

8. INSTALL BACK DOOR SIDE GARNISH LH Reassembly

9. INSTALL BACK DOOR SIDE GARNISH RH Reassembly

10. INSTALL BACK DOOR CENTER GARNISH Reassembly