Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
* w/ Navigation System:
After the engine switch is turned off, the display and navigation module display (navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH Disassembly

3. REMOVE REAR ARMREST ASSEMBLY LH Disassembly

4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH Disassembly

6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH Disassembly

7. REMOVE REAR SPEAKER ASSEMBLY Removal

8. REMOVE REAR DOOR SERVICE HOLE COVER LH Disassembly

9. REMOVE REAR DOOR GLASS RUN LH Disassembly

10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH Disassembly

11. REMOVE REAR DOOR QUARTER WINDOW GLASS LH Disassembly

12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH Disassembly

13. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH Disassembly

14. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH





(a) Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor.