Reassembly

L110 HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER: REASSEMBLY

REASSEMBLY

1. INSTALL TRANSMISSION CONTROL SWITCH






(a) Install the transmission control switch to the shift lever guide housing.
NOTE: Securely engage the claws.

2. INSTALL SHIFT LOCK CONTROL ECU SUB-ASSEMBLY






(a) Apply MP grease to the hatched area of the shift lever guide housing as indicated in the illustration.






(b) Install the shift lock control ECU sub-assembly with the 2 screws.






(c) Install the shift lever guide housing with the shift lever lock pin and a new shift lever nut.
- Install the shift lever nut and lock pin after first engaging the 2 claws.
- Securely engage the claws.





(d) Connect the transmission control switch connector to the floor shift assembly.
3. INSTALL POSITION INDICATOR SLIDE COVER






(a) Install position indicator slide cover No. 2 to the position indicator slide cover.
(b) Install the position indicator slide cover to the position indicator housing.
4. INSTALL POSITION INDICATOR LENS






(a) Install the position indicator lens to the position indicator housing lower.
NOTE: Securely engage the claws.

5. INSTALL SHIFT LEVER CAP
(a) Install the shift lever cap to the position indicator housing.
6. INSTALL POSITION INDICATOR HOUSING






(a) Install the position indicator housing upper to the position indicator housing lower.
NOTE: Securely engage the claws.

7. INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY






(a) Securely connect the 2 terminals of the indicator light wire harness to the transmission control switch connector.






(b) Install the position indicator light bulb to the indicator light wire sub-assembly.
(c) Install the position indicator bulb cap to the position indicator light bulb.






(d) Install the indicator light wire to the position indicator.
NOTE: Make sure that the indicator light wire is securely installed to the position indicator.

8. INSTALL SHIFT POSITION INDICATOR






(a) Install the shift position indicator to the console panel UPR assembly with the 2 screws.
HINT: Engage the 3 claws to install the indicator.





(b) Connect the indicator light wire harness connector and the wire harness to the console panel UPR assembly.