Removal

2UR-FSE ENGINE CONTROL SYSTEM: THROTTLE BODY: REMOVAL

REMOVAL

1. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

2. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

3. REMOVE NO. 1 AIR CLEANER INLET Removal

4. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Removal

5. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH Removal

6. REMOVE NO. 1 ENGINE UNDER COVER Removal

7. DRAIN ENGINE COOLANT Service and Repair







8. REMOVE INTAKE AIR CONNECTOR PIPE
(a) Disconnect the No. 1 and No. 2 ventilation hoses from the intake air connector pipe.
(b) Using a clip remover, detach the wire harness clamp.
(c) Loosen the 3 hose clamps, and remove the intake air connector pipe.
9. REMOVE THROTTLE BODY ASSEMBLY





(a) Disconnect the throttle motor connector.
(b) Remove the 4 bolts and throttle body.






(c) Disconnect the No. 4 and No. 5 water by-pass hoses from the throttle body.
(d) Remove the gasket from the intake manifold.