B2789

ENGINE IMMOBILIZER: ENGINE IMMOBILIZER SYSTEM: B2789: No Response from ID BOX

DTC B2789 - No Response from ID BOX

DESCRIPTION

This DTC is output when the certification ECU does not receive LIN communication from the ID code box for 10 seconds.






WIRING DIAGRAM





INSPECTION PROCEDURE
NOTE:
If the certification ECU or ID code box is replaced, register the key and ECU communication ID Engine Immobilizer System.

PROCEDURE

1. CHECK DTC OUTPUT
(a) Delete the DTCs Reading and Clearing Diagnostic Trouble Codes.
(b) Recheck for DTCs Reading and Clearing Diagnostic Trouble Codes.
Result:






B -- USE SIMULATION METHOD TO CHECK
A -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX)




(a) Disconnect the E13 ECU and E32 ID code box connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. REPLACE CERTIFICATION ECU
(a) Replace the certification ECU.
NEXT -- Continue to next step.
4. ELECTRICAL KEY REGISTRATION
(a) Register the electrical key code in the certification ECU Engine Immobilizer System.
NEXT -- Continue to next step.
5. ECU COMMUNICATION ID REGISTRATION
(a) Register the ECU communication ID between the ID code box and ECM Engine Immobilizer System.
NEXT -- Continue to next step.
6. CHECK DTC OUTPUT
(a) Delete the DTCs Reading and Clearing Diagnostic Trouble Codes.
(b) Recheck for DTCs Reading and Clearing Diagnostic Trouble Codes.
Result:






B -- END
A -- REPLACE ID CODE BOX