B2002

PRE-COLLISION: PRE-COLLISION SYSTEM: B2002: Open in Seat Belt Motor RH Circuit

DTC B2002 - Open in Seat Belt Motor RH Circuit

DESCRIPTION

The seat belt control ECU receives information from the distance control ECU through CAN communication and tightens the seat by operating the motor in the front seat outer belt RH.
CAUTION:
The pretension is built into the front seat outer belt RH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may activate the pretension.





WIRING DIAGRAM





INSPECTION PROCEDURE
NOTICE:
When the seat belt control ECU is replaced with a new one, Active Test must be performed Pre-Collision System.

PROCEDURE

1.
CHECK WIRE HARNESS (FRONT SEAT OUTER BELT RH - SEAT BELT CONTROL ECU)




(a) Disconnect the U8 belt connector.
(b) Disconnect the V42 ECU connector.
(c) Using a service wire, connect terminals U8-1 and U8-2 of the connector.
NOTICE:
Do not forcibly insert a service wire into the terminals of the connector when connecting them.
(d) Measure the resistance of the wire harness side connector.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2.
CHECK FRONT SEAT OUTER BELT ASSEMBLY RH




(a) Disconnect the service wire from the U8 belt connector.
(b) Reconnect the U8 belt connector.
(c) Disconnect the V42 ECU connector.
(d) Measure the resistance of the belt.
Standard resistance:






NG -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY RH
OK -- REPLACE SEAT BELT CONTROL ECU