Security Horn Circuit

THEFT DETERRENT: THEFT DETERRENT SYSTEM: Security Horn Circuit

Security Horn Circuit

DESCRIPTION
- When the theft deterrent system is operating, the main body ECU RH outputs a signal continuously at 0.4 second intervals, causing the security horn to sound.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY HORN)
(a) Select the Active Test, use the Techstream to generate a control command, and then check that the security horn sounds.

Main Body





OK:
Security horn operates normally.
OK -- REPLACE MAIN BODY ECU RH
NG -- Continue to next step.
2.
INSPECT SECURITY HORN ASSEMBLY




(a) Remove the security horn.
(b) Check operation of the horn.
OK:






NG -- REPLACE SECURITY HORN ASSEMBLY
OK -- Continue to next step.
3.
CHECK WIRE HARNESS (MAIN BODY ECU RH - SECURITY HORN ASSEMBLY)




(a) Disconnect the A39 ECU connector.
(b) Disconnect the A27 horn connector.
(c) Check the resistance of the wire harness side connectors.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE MAIN BODY ECU RH