TC and CG Terminal Circuit

CRUISE CONTROL: CRUISE CONTROL SYSTEM: TC and CG Terminal Circuit

TC and CG Terminal Circuit

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1.
CHECK WIRE HARNESS (DLC3 - HYBRID VEHICLE CONTROL ECU AND BODY GROUND)




(a) Disconnect the K16 DLC3 connector.
(b) Disconnect the A54 ECU connector.
(c) Measure the resistance of the wire harness side connectors.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE