Installation

2GR-FSE FUEL: FUEL PRESSURE PULSATION DAMPER: INSTALLATION

INSTALLATION

1. INSTALL FUEL PRESSURE PULSATION DAMPER
(a) Install 2 new gaskets, the fuel tube and fuel pressure pulsation damper to the fuel pump.





(b) Using SST, tighten the fuel pressure pulsation damper to the fuel pump.
SST: 09612-24014
09617-24011
Torque: 35 Nm (357 kgf-cm, 26ft-lbf)for use with SST
Torque: 40 Nm (408 kgf-cm, 30ft-lbf)for use without SST
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Make sure SST and wrench are connected in a straight line.

2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE Installation
3. CONNECT NO. 2 VENTILATION HOSE Installation
4. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
5. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation
6. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation
7. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation
8. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation
9. INSTALL FRONT UPPER FENDER PROTECTOR LH Installation
10. INSTALL FRONT UPPER FENDER PROTECTOR RH Installation
11. INSTALL V-BANK COVER SUB-ASSEMBLY Installation
12. INSTALL ENGINE ROOM SIDE COVER RH Installation
13. INSTALL ENGINE ROOM SIDE COVER LH Installation
14. INSTALL COOL AIR INTAKE DUCT SEAL Installation
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
16. INSTALL SERVICE PLUG GRIP Installation
17. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE:
Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.