Installation
INTERIOR: REAR SUNSHADE ASSEMBLY: INSTALLATION
INSTALLATION
1. INSTALL REAR SUNSHADE RELAY
(a) Install the relay with the 2 screws.
(b) Connect the connector.
(c) Attach the claw to install the relay cover.
2. INSTALL REAR WINDOW SUNSHADE ASSEMBLY
(a) Temporarily install the window sunshade by tightening bolt A.
(b) Install the window sunshade with the 5 bolts.
3. INSTALL NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY
(a) Connect the connector.
(b) Attach the 5 claws and 3 clips to install the panel.
4. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
(a) Attach the clip to install the package tray trim panel.
(b) Attach the 4 claws to install the belt guide center.
(c) Install the seat belt with the bolt labeled B.
Torque: 18.1 Nm (185 kgf-cm, 13ft-lbf)
(d) Connect the connector labeled A.
(e) Install the anchor of the rear seat outer belt with the bolt.
Torque: 18.1 Nm (185 kgf-cm, 13ft-lbf)
(f) Attach the 4 claws to install the belt guide LH.
5. INSTALL AUTOMATIC LIGHT CONTROL SENSOR
(a) Connect the connector and install the sensor.
6. INSTALL HIGH MOUNTED STOP LIGHT ASSEMBLY
(a) Install the high mounted stop light.
7. INSTALL ROOF SIDE GARNISH INNER LH
(a) Install the roof side garnish inner LH Installation.
8. INSTALL ROOF SIDE GARNISH INNER RH
(a) Install the roof side garnish inner RH Installation.
9. INSTALL REAR SEAT SIDE GARNISH LH
(a) Install the rear seat side garnish LH Installation.
10. INSTALL REAR SEAT SIDE GARNISH RH
(a) Install the rear seat side garnish RH Installation.
11. INSTALL REAR DOOR SCUFF PLATE LH
(a) Install the rear door scuff plate LH Installation.
12. INSTALL REAR DOOR SCUFF PLATE RH
(a) Install the rear door scuff plate RH Installation.
13. INSTALL REAR SEATBACK ASSEMBLY Installation
14. INSTALL REAR SEAT HEADREST ASSEMBLY CENTER
15. INSTALL REAR SEAT HEADREST ASSEMBLY LH
16. INSTALL REAR SEAT HEADREST ASSEMBLY RH
17. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
19. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.