Removal

PARKING BRAKE: ELECTRIC PARKING BRAKE SWITCH: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
2. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)
3. REMOVE BATTERY SERVICE HOLE COVER LH Removal
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

5. REMOVE BATTERY SERVICE HOLE COVER Removal
6. REMOVE INSTRUMENT SIDE PANEL LH Removal
7. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING Removal





8. REMOVE SWITCH BASE HOLE COVER
(a) Using a screwdriver, detach the claw and remove the cover from the No. 1 instrument panel safety pad.
HINT: Tape the screwdriver tip before use.

(b) Remove the screw.
9. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal
10. REMOVE ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
(a) Disconnect the connector.





(b) Remove the 3 screws and bracket from the No. 1 instrument panel safety pad.
(c) Remove the electric parking brake switch from the No. 1 instrument panel safety pad.