B2416

LIGHTING (EXT): LIGHTING SYSTEM: B2416: Height Control Sensor Malfunction
B2416 - Height Control Sensor Malfunction

DESCRIPTION

The DTC is stored when the AFS ECU (headlight swivel ECU assembly) detects malfunctions in the rear height control sensor sub-assembly RH power source or rear height control sensor sub-assembly RH.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK FOR DTC

(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(b) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.

OK:

DTC B2416 is not output.

NG -- READ VALUE USING TECHSTREAM

OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting

2. READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / AFS / Data List.

(e) Read the display on the Techstream.

AFS





OK:

Normal condition listed above is displayed.

NG -- CHECK HARNESS AND CONNECTOR (AFS ECU - HEIGHT CONTROL SENSOR)
OK -- Continue to next step.

3. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

(a) Connect 3 dry cell batteries (1.5 V) in series.





(b) Remove the rear height control sensor sub-assembly RH Components.

(c) Connect the positive (+) lead from the batteries to terminal 3 (SHB) and the negative (-) lead from the batteries to terminal 1 (SHG).

(d) Measure the voltage between terminals 2 (SHRL) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:





Text in Illustration





NG -- REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH Components

OK -- REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)

4. CHECK HARNESS AND CONNECTOR (AFS ECU - HEIGHT CONTROL SENSOR)

(a) Disconnect the A61 AFS ECU (headlight swivel ECU assembly) connector.

(b) Disconnect the O1 rear height control sensor sub-assembly RH connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

(a) Connect 3 dry cell batteries (1.5 V) in series.





(b) Remove the rear height control sensor sub-assembly RH Components.

(c) Connect the positive (+) lead from the batteries to terminal 3 (SHB) and the negative (-) lead from the batteries to terminal 1 (SHG).

(d) Measure the voltage between terminals 2 (SHRL) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:





Text in Illustration





NG -- REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH Components

OK -- REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)