Electronically Controlled Brake System
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: DIAGNOSTIC TROUBLE CODE CHART
NOTICE:
When replacing the brake booster with master cylinder (skid control ECU), sensor, etc., make sure that the power switch is turned off, the stop light switch is off, and 2 minutes have elapsed since the driver's door was closed.
HINT
* If no abnormality is found when inspecting parts, inspect the skid control ECU and ground points for poor connections.
* If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the page for the respective "DTC Code" in the DTC chart.
* When 2 or more DTCs are detected, perform circuit inspections one by one until the problem is identified.
* Inspect the fuses and relays before inspecting the trouble areas as shown in the table below.
ABS DTC
DTC 42 / C0200/31 - C0205/32:
C0210/33 - C0215-34:
C1235/35 - C1236-36:
C1238/38 - C1245/45:
C1336/98 - C1381/97 / U0124/95:
VSC DTC
DTC 43 - 45 / C1210/36 - 1439/66:
C1440/98 - C1445/66 / U0123/62 - U0126/63:
Electronically Controlled Brake System DTC
DTC 36 / C1202/68 - C1211/25:
C1212/26 - C1228/34:
C1242/42 -C1247/47:
C1249/49 - C1257/57:
C1259/58 - C1357/24:
C1364/61 - C1451/72:
U0073/94 - U0293/59:
ABS and Electronically Controlled Brake System DTC
C1241/41:
*1: Electronically Controlled Brake System DTC
*2: ABS DTC
ABS Test Mode DTC
C1271/71 - C1279/79:
C1281/81:
VSC Test Mode DTC
C0371/71:
Electronically Controlled Brake System Test Mode DTC
