P060E
2AZ-FXE ENGINE CONTROL: SFI SYSTEM: P060E: Internal Control Module Throttle Position Performance
P060E - Internal Control Module Throttle Position Performance
MONITOR DESCRIPTION
The hybrid vehicle control ECU monitors the input signals of the No. 1 throttle position sensor. When the hybrid vehicle control ECU monitors the input signal of the No. 1 throttle position sensor, if the input signal and control signal deviate, the DTC is stored.
MONITOR STRATEGY
TYPICAL ENABLING CONDITIONS
TYPICAL MALFUNCTION THRESHOLDS
CONFIRMATION DRIVING PATTERN
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and turn the Techstream on.
- Clear the DTCs DTC Check / Clear.
- Turn the power switch off and wait for at least 30 seconds.
- Turn the power switch on (IG) and turn the Techstream on.
- Wait 16 seconds or more [A].
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTC [B].
HINT
- If a DTC is output, the system is malfunctioning.
- If a DTC is not output, perform the following procedure.
- Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
- Input the DTC: P060E.
- Check the DTC judgment result.
HINT
If the judgment result shows ABNORMAL, the system has a malfunction.
INSPECTION PROCEDURE
PROCEDURE
1. READ OUTPUT DTC (DTC P060E)
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Clear the DTCs DTC Check / Clear.
(e) Turn the power switch off and turn the Techstream off.
(f) Disconnect the Techstream.
(g) Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.
(h) Connect the cable to the battery negative (-) terminal.
(i) Connect the Techstream to the DLC3.
(j) Turn the power switch on (IG).
(k) Wait 16 seconds or more.
(l) Turn the Techstream on.
(m) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(n) Read the DTCs.
Result:
B -- REPLACE HYBRID VEHICLE CONTROL ECU Removal
A -- CHECK FOR INTERMITTENT PROBLEMS