P0657

2AZ-FXE ENGINE CONTROL: SFI SYSTEM: P0657: Actuator Supply Voltage Circuit / Open
P0657 - Actuator Supply Voltage Circuit / Open

MONITOR DESCRIPTION

The hybrid vehicle control ECU monitors the output voltage to the throttle actuator. This self-check ensures that the hybrid vehicle control ECU is functioning properly. The output voltage is usually 0 V when the power switch is turned off. If the output voltage is higher than 7 V when the power switch is turned off, the hybrid vehicle control ECU will illuminate the MIL and set the DTC the next time the power switch is turned on (IG).





MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





TYPICAL MALFUNCTION THRESHOLDS





CONFIRMATION DRIVING PATTERN





- Connect the Techstream to the DLC3.

- Turn the power switch on (IG) and turn the Techstream on.

- Clear the DTCs DTC Check / Clear.

- Turn the power switch off and wait for at least 30 seconds.

- Turn the power switch on (IG) and turn the Techstream on.

- Wait 5 seconds or more [A].

- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

- Read the DTC [B].

HINT
- If a DTC is output, the system is malfunctioning.
- If a DTC is not output, perform the following procedure.
- Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.

- Input the DTC: P0657.

- Check the DTC judgment result.





HINT
If the judgment result shows ABNORMAL, the system has a malfunction.

INSPECTION PROCEDURE

HINT
Read freeze frame data using the Techstream. The hybrid vehicle control ECU records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

PROCEDURE

1. READ OUTPUT DTC (DTC P0657)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Clear the DTCs DTC Check / Clear.

(e) Turn the power switch off and turn the Techstream off.

(f) Disconnect the Techstream.

(g) Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.

(h) Connect the cable to the battery negative (-) terminal.

(i) Turn the power switch on (IG) for 10 seconds.

(j) Turn the power switch off.

(k) Connect the Techstream to the DLC3.

(l) Turn the power switch on (IG).

(m) Wait 16 seconds or more.

(n) Turn the Techstream on.

(o) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

(p) Read the DTCs.

Result:





B -- REPLACE HYBRID VEHICLE CONTROL ECU Removal

A -- CHECK FOR INTERMITTENT PROBLEMS