Installation
EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION
1. INSTALL FRONT BUMPER ASSEMBLY
(a) Connect the headlight cleaner hose. (w/ Headlight Cleaner System)
(b) Connect the connector. (w/o Wide View Front Monitor System)
(c) Connect the 2 connectors. (w/ Wide View Front Monitor System)
(d) Engage the 2 claws and install the front bumper assembly as shown in the illustration.
Text in Illustration
(e) Connect the hood to radiator grille seal.
(f) Engage the 4 claws to install the front bumper assembly.
HINT
Use the same procedure for the RH side and LH side.
(g) Install the 3 clips.
(h) Install the 2 bolts.
(i) Install the 8 screws.
(j) Install the front bumper seal bracket.
NOTICE:
Do not pull the front bumper assembly after the front bumper seal bracket is installed, or the front bumper assembly may be damaged.
HINT
Use the same procedure for the RH side and LH side.
(k) Install the screw.
HINT
Use the same procedure for the RH side and LH side.
(l) Install the 2 pin hold clips.
Text in Illustration
NOTICE:
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.
HINT
Use the same procedure for the RH side and LH side.
2. INSTALL HOOD CENTER CUSHION
(a) Install the 2 hood center cushions.
3. INSTALL COOL AIR INTAKE DUCT SEAL
(a) Install the cool air intake duct seal with the 11 clips.
4. ADD WASHER FLUID (w/ Headlight Cleaner System) Installation
5. ADJUST FOG LIGHT AIMING
(a) Adjust the fog light aiming. Adjustments