Removal
HEATING / AIR CONDITIONING: BLOWER UNIT (for Rear Side): REMOVAL
1. PRECAUTION (w/ Navigation System)
NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal
4. REMOVE FRONT CONSOLE BOX COVER Removal
5. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (w/o Seat Heater System) Removal
6. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (w/ Seat Heater System) Removal
7. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY Removal
8. REMOVE CONSOLE BOX CARPET Removal
9. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY Removal
10. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal
11. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal
12. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY (w/o Navigation System) Removal
13. REMOVE REMOTE TOUCH ASSEMBLY (w/ Navigation System) Removal
14. REMOVE CONSOLE BOX LH Removal
15. REMOVE CONSOLE BOX RH Removal
16. REMOVE FRONT DOOR SCUFF PLATE RH
HINT
Use the same procedure for the RH side and LH side Removal.
17. REMOVE FRONT DOOR OPENING TRIM COVER RH
HINT
Use the same procedure for the RH side and LH side Removal.
18. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
19. REMOVE COWL SIDE TRIM BOARD RH
HINT
Use the same procedure for the RH side and LH side Removal.
20. REMOVE INSTRUMENT SIDE PANEL RH Removal
21. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal
22. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal
23. REMOVE CONSOLE BOX Removal
24. REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET Removal
25. REMOVE NO. 4 CONSOLE BOX DUCT
(a) Remove the 2 screws.
(b) Remove the No. 4 console box duct as shown in the illustration.
26. REMOVE NO. 1 CONSOLE BOX MOUNTING BRACKET
(a) Remove the 2 clips.
(b) Remove the 7 bolts and No. 1 console box mounting bracket as shown in the illustration.
27. REMOVE COOLER BLOWER ASSEMBLY
(a) Disengage the clamp.
(b) Disconnect the connector and remove the cooler blower assembly.