Operation CHARM: Car repair manuals for everyone.
Home >> Lexus >> 2010 >> LS 600h V8-5.0L (2UR-FSE) Hybrid >> Repair and Diagnosis >> Sensors and Switches >> Sensors and Switches - Brakes and Traction Control >> Acceleration/Deceleration Sensor >> Service and Repair >> Removal

Removal





BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: REMOVAL

NOTICE:
While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal

2. REMOVE BATTERY SERVICE HOLE COVER LH Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
* After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

7. REMOVE NO. 3 BOX PANEL Removal

8. REMOVE REAR CONSOLE PANEL UPPER Removal

9. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER Removal

10. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY Removal

11. REMOVE CONSOLE COVER LOWER Removal

12. REMOVE CONSOLE BOX ASSEMBLY Removal

13. REMOVE NO. 1 CONSOLE BOX DUCT

(a) Detach the connector clamp.





(b) Remove the 2 clips and No. 1 duct.

14. REMOVE YAW RATE SENSOR

(a) Remove the 2 bolts and sensor.





(b) Disconnect the sensor connector.

NOTICE:
* Make sure the yaw rate sensor's identification number is 9.
* Do not drop the yaw rate sensor. If it is dropped, do not use it.
pro multis · About Operation CHARM