Active Stabilizer Suspension System
SUSPENSION CONTROL: ACTIVE STABILIZER SUSPENSION SYSTEM: DTC CHECK / CLEAR
1. CHECK DTC
(a) Turn the power switch OFF.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch ON (READY) and wait 30 seconds or more.
HINT
As the power switch must be ON (READY) in order to detect certain DTCs, make sure the power switch is ON (READY).
(d) Turn the Techstream on.
(e) Enter the following menus (Front active stabilizer): Chassis / Front Stabilizer / Trouble Codes.
(f) Enter the following menus (Rear active stabilizer): Chassis / Rear Stabilizer / Trouble Codes.
(g) Read the DTCs by following the prompts on the Techstream screen.
HINT
Refer to the Techstream operator's manual for further details.
(h) Refer to the "DIAGNOSTIC TROUBLE CODE CHART" for DTC information Active Stabilizer Suspension System.
2. CLEAR DTC
(a) Turn the power switch OFF.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch ON (IG).
(d) Turn the Techstream on.
(e) Enter the following menus (Front active stabilizer): Chassis / Front Stabilizer / Trouble Codes.
(f) Enter the following menus (Rear active stabilizer): Chassis / Rear Stabilizer / Trouble Codes.
(g) Clear DTCs.