Installation

U660E AUTOMATIC TRANSAXLE: SHIFT LEVER: INSTALLATION

1. INSTALL SHIFT LEVER ASSEMBLY

(a) Install the 4 bolts and shift lever assembly.





Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(b) Connect the shift lock control ECU connector and transmission control switch wire connector.





2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Install the transmission control cable assembly as shown in the illustration.





HINT
* Install the floor shift cable with the uneven surface facing up.
* Securely engage the claws of the floor shift cable.

3. INSTALL NO. 3 CONSOLE BOX DUCT Installation

4. INSTALL NO. 2 CONSOLE BOX DUCT Installation

5. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

6. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY Installation

7. INSTALL CONSOLE BOX CARPET Installation

8. INSTALL CONSOLE BOX POCKET Installation

9. INSTALL HEATER SEAT SWITCH CONSOLE BASE (w/o Seat Heater System) Installation

10. INSTALL HEATER SEAT SWITCH CONSOLE BASE (w/ Seat Heater System) Installation

11. INSTALL UPPER CONSOLE PANEL ASSEMBLY WITH FRONT ASH RECEPTACLE Installation

12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

13. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

14. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

15. INSPECT SHIFT LEVER POSITION Adjustments

16. ADJUST SHIFT LEVER POSITION Adjustments