Removal

NAVIGATION: MULTI-DISPLAY (w/ Navigation System): REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
* A hard disk drive (HDD) is built into the display and navigation module display (HDD navigation system) to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the display and navigation module display (HDD navigation system).

2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT Removal

3. REMOVE BATTERY SERVICE HOLE COVER LH Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

5. REMOVE FRONT CONSOLE UPPER PANEL GARNISH Removal

6. REMOVE CONSOLE UPPER PANEL ASSEMBLY Removal

7. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

8. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

9. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY Removal

10. REMOVE HARD DISK DRIVE (w/ Navigation System for HDD) Removal

11. REMOVE TIRE PRESSURE MONITOR ECU Removal

12. REMOVE NO. 2 RADIO BRACKET Removal

13. REMOVE NO. 1 RADIO BRACKET Removal

14. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY