All Doors Lock/Unlock Functions Do Not Operate Via Door Control Switch

DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch
- All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch

DESCRIPTION

The main body ECU RH receives switch signals from the door control switch and activates the door lock motor on each door according to the signals.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FUSE (FR DOOR RH, MPX-B, D/C CUT)

(a) Remove the FR DOOR RH fuse from the main body ECU RH.

(b) Remove the MPX-B and D/C CUT fuses from the engine room No. 1 relay block.

(c) Measure the resistance of the fuses.

Standard resistance:

Below 1 Ohms

NG -- REPLACE FUSE
OK -- Continue to next step.

2. CHECK WIRE HARNESS (DOOR ECU - BATTERY AND BODY GROUND)

(a) Disconnect the M4 ECU connector.

(b) Measure the voltage of the wire harness side connector.

Standard voltage:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. INSPECT DOOR CONTROL SWITCH ASSEMBLY

(a) Remove the door control switch.

(b) Measure the resistance of the switch.

Standard resistance:

NG -- REPLACE DOOR CONTROL SWITCH ASSEMBLY
OK -- Continue to next step.

4. CHECK WIRE HARNESS (SWITCH - ECU)

(a) Disconnect the Q3 switch connector.

(b) Disconnect the M3 ECU connector.

(c) Measure the resistance of the wire harness side connectors.

Standard resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. REPLACE FRONT MULTIPLEX NETWORK DOOR ECU RH

(a) After replacing the front multiplex network door ECU RH with a normal one, check that all doors can be locked and unlocked by using the door control switch.

OK:

All doors can be locked and unlocked with door control switch.

NG -- REPLACE MAIN BODY ECU RH

OK -- END