Sliding Roof Does Not Move By Operating Sliding Roof Control Switch

SLIDING ROOF / CONVERTIBLE: SLIDING ROOF SYSTEM: Sliding Roof does not Move by Operating Sliding Roof Control Switch
- Sliding Roof does not Move by Operating Sliding Roof Control Switch

DESCRIPTION

The sliding roof drive gear sub-assembly (sliding roof ECU) receives slide and tilt signals when the sliding roof switch is operated and drives its built-in motor.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.
* When the sliding roof ECU (sliding roof drive gear sub-assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear sub-assembly) must be initialized Initialization.
* Since the sliding roof system has functions that use LIN communication, first confirm that there is no malfunction in the LIN communication system with the How to Proceed with Troubleshooting procedure How To Proceed With Troubleshooting.

PROCEDURE

1. READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Sliding Roof / Data List.

(e) Read the Data List according to the display on the Techstream.

Sliding Roof (Sliding Roof ECU (Sliding Roof Drive Gear Sub-assembly))





OK:

The Techstream display changes according to switch operation as shown in the table.

NG -- INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - AUXILIARY BATTERY, BODY GROUND)

(a) Disconnect the P6 sliding roof ECU (sliding roof drive gear sub-assembly) connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) Removal

3. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)

(a) Remove the map light assembly (sliding roof switch assembly) Removal.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPLACE SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY) Removal
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - SLIDING ROOF SWITCH)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) Removal