Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL

1. REMOVE FRONT SEAT ASSEMBLY

Removal

2. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

Removal

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

5. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY (w/o Navigation System) Removal

6. REMOVE REMOTE TOUCH ASSEMBLY (w/ Navigation System) Removal

7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal

8. REMOVE FRONT CONSOLE BOX COVER Removal

9. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (w/o Seat Heater System) Removal

10. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (w/ Seat Heater System) Removal

11. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY Removal

12. REMOVE CONSOLE BOX CARPET Removal

13. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY Removal

14. REMOVE CONSOLE BOX LH Removal

15. REMOVE CONSOLE BOX RH Removal

16. REMOVE CONSOLE BOX Removal

17. REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET Removal

18. REMOVE NO. 4 CONSOLE BOX DUCT Removal

19. REMOVE NO. 1 CONSOLE BOX MOUNTING BRACKET Removal

20. REMOVE COOLER BLOWER ASSEMBLY Removal

21. REMOVE NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY Removal

22. REMOVE NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY Removal

23. REMOVE REAR NO. 2 AIR DUCT

(a) Disengage the 6 claws and remove the rear No. 2 air duct.

24. REMOVE CENTER AIRBAG SENSOR ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Disconnect the connectors from the center airbag sensor assembly as shown in the illustration.





NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(d) Remove the 3 bolts and center airbag sensor assembly.