Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. PRECAUTION (w/ Navigation System)

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal

3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

5. REMOVE REAR DOOR ARMREST COVER Disassembly

6. REMOVE NO. 1 REAR DOOR STIFFENER CUSHION Disassembly

7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP Disassembly

9. REMOVE REAR DOOR ARMREST SET BRACKET Disassembly

10. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

11. REMOVE REAR DOOR GLASS RUN Disassembly

12. REMOVE NO. 2 REAR DOOR VENT SEAL Disassembly

13. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY Disassembly

14. REMOVE REAR DOOR QUARTER WINDOW GLASS Disassembly

15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

16. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY Disassembly

17. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" driver, remove the 3 screws and the rear power window regulator motor assembly.