B1243

DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: B1243: GSW Terminal Circuit Malfunction
B1243 - GSW Terminal Circuit Malfunction

DESCRIPTION

If the collision door lock release function does not operate normally, or an open or short in the GSW input circuit of the main body ECU RH (cowl side junction block RH) is detected, DTC B1243 will be stored.

HINT
If DTC B1243 is stored, the speed-sensitive automatic door lock function, shift-linked automatic door lock function, and collision door lock release function will be prohibited.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK DTC OUTPUT

(a) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.

(b) Check for DTCs.

OK:

DTC B1243 is not output.

NG -- CHECK MAIN BODY ECU RH (COWL SIDE JUNCTION BLOCK RH ) (GSW VOLTAGE)

OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting

2. CHECK MAIN BODY ECU RH (COWL SIDE JUNCTION BLOCK RH ) (GSW VOLTAGE)

(a) Disconnect the cable from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(b) Disconnect the center airbag sensor assembly connector.

(c) Connect the cable to the negative (-) battery terminal.

(d) Measure the voltage according to the value(s) in the table below.





Standard Voltage:





Text in Illustration





NOTICE:
Turning the engine switch on (IG) with the center air bag sensor assembly connector disconnected causes other DTCs to be stored. Clear the DTCs after performing this inspection.

NG -- CHECK HARNESS AND CONNECTOR (CENTER AIRBAG SENSOR - MAIN BODY ECU RH)
OK -- Continue to next step.

3. REPLACE CENTER AIRBAG SENSOR ASSEMBLY

(a) Disconnect the cable from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(b) Replace the center airbag sensor assembly Removal.

NEXT -- Continue to next step.

4. CHECK DTC OUTPUT

(a) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.

(b) Recheck for DTCs.

OK:

DTC B1243 is not output.

NG -- REPLACE MAIN BODY ECU RH (COWL SIDE JUNCTION BLOCK RH)

OK -- END (CENTER AIRBAG SENSOR ASSEMBLY WAS DEFECTIVE)

5. CHECK HARNESS AND CONNECTOR (CENTER AIRBAG SENSOR - MAIN BODY ECU RH)

(a) Disconnect the cable from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(b) Disconnect the center airbag sensor assembly connector.

(c) Disconnect the main body ECU RH (cowl side junction block RH) connector.





(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE MAIN BODY ECU RH (COWL SIDE JUNCTION BLOCK RH)