Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH Disassembly

5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL Disassembly

6. REMOVE COURTESY LIGHT ASSEMBLY Removal

7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

8. REMOVE FRONT DOOR TRIM COVER Disassembly

9. REMOVE FRONT DOOR SERVICE HOLE COVER

(a) Disconnect the door side airbag sensor connector.

(b) Remove the front door service hole cover Disassembly.

10. REMOVE FRONT DOOR UPPER WINDOW STOP Disassembly

11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly

12. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY Disassembly

13. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a screwdriver, disengage the 4 claws and guide, and remove the front door power window regulator base plate.





(b) Using needle nose pliers, remove the drum and wire guide from the power window regulator motor assembly.





NOTICE:
Do not use a screwdriver to remove them. Using a screwdriver may damage the regulator wire.