B2524

SLIDING ROOF / CONVERTIBLE: RETRACTABLE HARDTOP SYSTEM: B2524: Roof Position Switch No. 2 Malfunction
B2524 - Roof Position Switch No. 2 Malfunction

DESCRIPTION

The No. 2 roof half open switch, which is located in the roof panel strength sub-assembly, detects that the roof is half open. The switch sends a signal to the sliding roof control ECU assembly.

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
Before starting troubleshooting, check that there are no mechanical problems.

PROCEDURE

1. READ VALUE USING TECHSTREAM (ROOF POSITION SW NO. 2)

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Retractable Hardtop / Data List.

(e) Read the Data List according to the display on the Techstream.

Retractable Hardtop (Sliding Roof Control ECU Assembly)

OK:

The Techstream display changes according to condition as shown in the table.

NG -- INSPECT ROOF PANEL STRENGTH SUB-ASSEMBLY (NO. 2 ROOF HALF OPEN SWITCH)

OK -- REPLACE SLIDING ROOF CONTROL ECU ASSEMBLY

2. INSPECT ROOF PANEL STRENGTH SUB-ASSEMBLY (NO. 2 ROOF HALF OPEN SWITCH)

(a) Check that the wire harness of the No. 2 roof half open switch has not been pinched by the body.

(b) Disconnect the A connector.

Text in Illustration

NG -- REPLACE ROOF PANEL STRENGTH SUB-ASSEMBLY (NO. 2 ROOF HALF OPEN SWITCH)
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (SLIDING ROOF DRIVE GEAR RH - SLIDING ROOF CONTROL ECU)

(a) Disconnect the P56 and P53 connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. CHECK SLIDING ROOF DRIVE GEAR ASSEMBLY RH (HARNESS AND CONNECTOR)

(a) Disconnect the P56 and A connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- REPLACE SLIDING ROOF DRIVE GEAR ASSEMBLY RH (HARNESS OR CONNECTOR)
OK -- Continue to next step.

5. INSPECT ROOF PANEL STRENGTH SUB-ASSEMBLY

(a) Disconnect the P56 connector.

(b) Measure the resistance according to the value(s) in the table below.

NOTICE:
Manually move the roof to the position in the table below Procedures.

Standard Resistance:

Text in Illustration

NG -- REPLACE ROOF PANEL STRENGTH SUB-ASSEMBLY

OK -- REPLACE SLIDING ROOF CONTROL ECU ASSEMBLY