B253E

SLIDING ROOF / CONVERTIBLE: RETRACTABLE HARDTOP SYSTEM: B253E: Side Package Tray Switch No.2 RH Abnormal Operation
B253E - Side Package Tray Switch No.2 RH Abnormal Operation

DESCRIPTION

The No. 1 package tray trim hinge (No. 2 side package tray RH switch) detects that the side package tray RH position. The switch sends a signal to the sliding roof control ECU assembly.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Before starting troubleshooting, check that there are no mechanical problems.

PROCEDURE

1. READ VALUE USING TECHSTREAM (RH SIDE PAC TRAY SW NO. 2)

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Retractable Hardtop / Data List.

(e) Read the Data List according to the display on the Techstream.

Retractable Hardtop (Sliding Roof Control ECU Assembly)





OK:

The Techstream display changes according to condition as shown in the table.

NG -- INSPECT NO. 1 PACKAGE TRAY TRIM HINGE

OK -- REPLACE SLIDING ROOF CONTROL ECU ASSEMBLY

2. INSPECT NO. 1 PACKAGE TRAY TRIM HINGE

(a) Check that the wire harness of the No. 2 side package tray RH switch has not been pinched by the body.

(b) Disconnect the h9 connector.





Text in Illustration





(c) Remove the slide roof motor assembly (side package tray motor).

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE NO. 1 PACKAGE TRAY TRIM HINGE
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (NO. 1 PACKAGE TRAY TRIM HINGE - SLIDING ROOF CONTROL ECU)

(a) Disconnect the h9 and Q36 connectors.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE SLIDING ROOF CONTROL ECU ASSEMBLY