B2560

SLIDING ROOF / CONVERTIBLE: RETRACTABLE HARDTOP SYSTEM: B2560: Motor Lock in Roof Lock Motor
B2560 - Motor Lock in Roof Lock Motor

DESCRIPTION

The sliding roof drive gear sub-assembly (roof front lock motor) locks/unlocks the roof lock when the roof panels are fully closed, and locks/unlocks the roof retaining mechanism when the roof panels are stowed in the luggage compartment.

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
* Before starting troubleshooting, manually move Procedures the roof links to check that they are not sticking or binding.
* Since this malfunction may be detected due to the protection circuit operation in the motor, check that the motor has cooled down sufficiently before performing DTC check again.
* These DTCs are stored when the protection circuit in the motor operates due to a mechanical malfunction during metal top system operation.

PROCEDURE

1. INSPECT SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (ROOF FRONT LOCK MOTOR)

(a) Remove the sliding roof drive gear sub-assembly (roof front lock motor).

(b) Apply battery voltage and check operation of the roof front lock motor.

OK:

(c) Connect an electrical tester DC 400 A probe to the wire harness of the motor.

NOTICE:
Match the arrow mark of the probe with the direction of the current flow.

(d) Measure the current according to the value(s) in the table below.

NOTICE:
Make sure to perform the inspection after the motor cools down sufficiently. Otherwise the result may not meet the specified condition due to protection circuit operation in the motor.

Standard Current:

Text in Illustration

NG -- REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
OK -- Continue to next step.

2. INSPECT REMOVABLE ROOF LOCK SUB-ASSEMBLY (ROOF FRONT LOCK SWITCH)

(a) Check that the wire harness of the roof front lock switch has not been pinched by the body.

(b) Disconnect the e2 connector.

Text in Illustration

NG -- REPLACE REMOVABLE ROOF LOCK SUB-ASSEMBLY (ROOF FRONT LOCK SWITCH)
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (REMOVABLE ROOF LOCK SUB-ASSEMBLY - SLIDING ROOF CONTROL ECU)

(a) Disconnect the e2 and P53 connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. INSPECT REMOVABLE ROOF LOCK SUB-ASSEMBLY (ROOF FRONT LOCK SWITCH)

(a) Disconnect the e1 and e2 connectors.

(b) Apply battery voltage to the motor connector and measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- REPLACE REMOVABLE ROOF LOCK SUB-ASSEMBLY (ROOF FRONT LOCK SWITCH)

OK -- REPLACE SLIDING ROOF CONTROL ECU ASSEMBLY