Removal

2UR-GSE FUEL: FUEL PRESSURE PULSATION DAMPER (for Port Injection): REMOVAL

1. PRECAUTION

2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. REMOVE ENGINE ROOM SIDE COVER RH Removal

5. REMOVE ENGINE ROOM SIDE COVER LH Removal

6. DISCHARGE FUEL SYSTEM PRESSURE

(a) Discharge fuel system pressure Service Precautions.

7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. REMOVE NO. 1 AIR CLEANER INLET Removal

9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal

11. REMOVE ENGINE UNDER COVER

12. DRAIN ENGINE COOLANT Service and Repair

13. SEPARATE ENGINE WIRE Removal

14. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY Removal

15. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY Removal

16. REMOVE NO. 3 FUEL HOSE Removal

17. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY (for Port Injection)

(a) Disconnect the 4 connectors.





(b) Remove the 2 bolts and wire harness.

(c) Disconnect the 4 connectors.





(d) Remove the 2 bolts and wire harness.

(e) Using SST, loosen the 2 fuel pressure pulsation dampers.





SST : 09612-24014

09617-24011

(f) Remove the fuel tube sub-assembly with the 4 gaskets.