Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly

3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

5. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP Disassembly

6. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

7. REMOVE REAR DOOR GLASS RUN Disassembly

8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY Disassembly

9. REMOVE REAR DOOR QUARTER WINDOW GLASS Disassembly

10. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

11. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY Disassembly

12. REMOVE REAR POWER WINDOW REGULATOR MOTOR

(a) Using a "TORX" socket wrench (T25), remove the 3 screws and the rear power window regulator motor.