Removal

DOOR LOCK: DOOR CONTROL TRANSMITTER: REMOVAL

1. REMOVE TRANSMITTER BATTERY

NOTICE:
Take extra care when handling these precision electronic components.

(a) Push and hold the release knob in the direction indicated by the arrow in the illustration. Then take the mechanical key out of the case.





(b) Insert a precision screwdriver into the gap, and turn the screwdriver to detach the transmitter housing cover.





HINT
Tape the screwdriver tip before use.

(c) Insert a precision screwdriver into the gap and remove the battery (lithium battery: CR1632).





NOTICE:
* Do not push the terminals with your finger.
* Do not forcibly pry up the battery. The terminals may be damaged.
* Do not touch the battery with wet hands. Water may cause rust.
* Do not touch or move any components inside the transmitter. It may interfere with proper operation.
* When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

2. REMOVE TRANSMITTER BATTERY (for Card Type)

(a) Lightly hold and pull the transmitter housing cover in the direction of the arrow as shown in the illustration.





NOTICE:
* Do not insert a screwdriver, etc. between the case and battery cover and forcefully bend the battery cover. This will deform the battery cover.
* When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

HINT
* If the battery cover is held too firmly, it becomes harder to pull out.
* If the cover is slippery and is difficult to pull out, use non-slip gloves to pull the cover out.

(b) Remove the transmitter battery (lithium battery: CR2412).





NOTICE:
When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.