Navigation ECU Communication Stop Mode

NETWORKING: CAN COMMUNICATION SYSTEM: Navigation ECU Communication Stop Mode
- Navigation ECU Communication Stop Mode

DESCRIPTION

* *1: w/ Navigation System (for DVD)

* *2: w/ Navigation System (for HDD)

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
* Turn the power switch off before measuring the resistances between CAN main bus lines and between CAN branch lines.
* Turn the power switch off before inspecting CAN bus lines for a ground short.
* After the power switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
* Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT
* Operating the power switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
* Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

PROCEDURE

1. CHECK CAN BUS LINE FOR DISCONNECTION (NAVIGATION ECU BRANCH LINE)

(a) Turn the power switch off.

(b) Disconnect the navigation ECU connector.

Text in Illustration

NG -- REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (NAVIGATION ECU)
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Text in Illustration

Result:

B -- REPLACE NAVIGATION COMPUTER SUB-ASSEMBLY (NAVIGATION ECU) Removal

C -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

A -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (NAVIGATION ECU) Removal