Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: REMOVAL

NOTICE:
* Do not remove the steering angle sensor from the spiral cable.
* While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the battery is connected.

1. REMOVE STEERING WHEEL ASSEMBLY

Removal

2. REMOVE STEERING COLUMN COVER Removal

3. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

(a) Remove the spiral cable with sensor sub-assembly Removal.

NOTICE:
* Do not replace the spiral cable with sensor sub-assembly with the battery connected and the power switch on (IG).
* Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the power switch on (IG).
* Ensure that the steering wheel is installed and aligned straight when inspecting the spiral cable with sensor sub-assembly.
* Do not remove the steering angle sensor from the spiral cable.