Pattern Select Switch Eco Mode Circuit

HYBRID / BATTERY CONTROL: HYBRID CONTROL SYSTEM: Pattern Select Switch Eco Mode Circuit
- Pattern Select Switch Eco Mode Circuit

DESCRIPTION

When selecting ECO mode, the switch operation signal is sent to the air conditioning amplifier assembly. Following this, ECO mode control is activated for the heater and air conditioning system.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (CAN BUS CHECK) EV Drive Mode Switch Circuit

B -- GO TO CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

2. CHECK DTC OUTPUT (ALL) EV Drive Mode Switch Circuit

B -- GO TO DTC CHART
A -- Continue to next step.

3. PERFORM ACTIVE TEST USING TECHSTREAM (COMBINATION METER)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (READY).

(c) Enter the following menus: Body Electrical / Combination Meter / Active Test / Indicator. ECONO.

(d) Perform the "Indicator. ECONO" Active Test.

OK:

The ECO mode indicator lamp blinks.

(e) Turn the power switch off.

NG -- REPLACE COMBINATION METER ASSEMBLY Components
OK -- Continue to next step.

4. READ VALUE USING TECHSTREAM (ECO SWITCH)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Enter the following menus: Body Electrical / Air Conditioning / Data List / ECO Switch.

(d) Read the value displayed on the Techstream.





Result:





B -- CHECK COMBINATION SWITCH ASSEMBLY (ECO SWITCH)

A -- CHECK FOR INTERMITTENT PROBLEMS Check for Intermittent Problems

5. CHECK COMBINATION SWITCH ASSEMBLY (ECO SWITCH)

(a) Remove the combination switch assembly.

(b) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





Text in Illustration





(c) Install the combination switch assembly.

NG -- REPLACE COMBINATION SWITCH ASSEMBLY Components
OK -- Continue to next step.

6. CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH ASSEMBLY - BODY GROUND)

(a) Disconnect connector from the combination switch assembly.

(b) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





Text in Illustration





(c) Connect the combination switch assembly connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

7. CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH ASSEMBLY - AIR CONDITIONING AMPLIFIER)

(a) Disconnect connector F47 from the air conditioning amplifier assembly.

(b) Disconnect connector from the combination switch assembly.

(c) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





Text in Illustration





(d) Connect the combination switch assembly connector.

(e) Connect the air conditioning amplifier assembly connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY Components