Removal

POWER DISTRIBUTION: POWER MANAGEMENT CONTROL ECU: REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal

4. REMOVE FRONT DOOR SCUFF PLATE RH

HINT
Use the same procedure for the RH side and LH side Removal.

5. REMOVE FRONT DOOR OPENING TRIM COVER RH

HINT
Use the same procedure for the RH side and LH side Removal.

6. REMOVE COWL SIDE TRIM BOARD RH

HINT
Use the same procedure for the RH side and LH side Removal.

7. REMOVE INSTRUMENT SIDE PANEL RH Removal

8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

9. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal

10. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal

11. REMOVE ECU INTEGRATION BOX RH

(a) Disconnect each connector.





(b) Disengage the clamp and disconnect the wire harness.

(c) Remove the bolt, 2 nuts and ECU integration box RH.

12. REMOVE POWER MANAGEMENT CONTROL ECU

(a) Disengage the 2 claws and remove the power management control ECU as shown in the illustration.